You can also install Solaris 8, Solaris 9, Solaris 10 and Solaris 11 on . List the logical domain devices using ldm list-device -a command. Use the ps command to check the process list whether the ldmd and vntsd is there in the process list or fmd_config/fmd_to_ldmd_running_timeout integer 10 general/action_authorization astring LDOMs known as Oracle VM Server for Sparc provides a Solaris feature The following commands can be used in connection with Solaris
|Published (Last):||28 March 2014|
|PDF File Size:||1.74 Mb|
|ePub File Size:||12.9 Mb|
|Price:||Free* [*Free Regsitration Required]|
LDOM also allows you to configure zones under that.
Logical Domains Commands
Download the LDOM packages from the oracle support website. Once you have downloaded the packages ,just copy the packages to the Solaris host which you have already installed on T- series server.
Create a new virtual disk service. This service is responsible to provide the virtual disks to guest domains. Create a new virtual switch. Creating the spconfig is must after making any changes on the service. Otherwise you will loose the changes after the system power cycle.
You need to login to Solaris host where you have installed the ldom software to configure the control domain. List the logical domain devices using ldm list-device -a command.
You can see all the resource has been allocated to the primary domain. Set the resource control for the control domain aka primary domain. These are all in-memory configuration. You have to save the configuration after every ldom settings that you made.
In the above command output, you can see that currents settings are saved in unixarena and these settings will come up after the system reboot and power cycle. Here we just increased the number vpcus to The previous cokmands of vpcu was 8. Which mean you will lose the CPU setting you just done.
In an order to save the configuration, just re-create the sp-config like below. In this article we have seen the basic concepts of Oracle VM sollaris SPARC LDOMpackages installation, the configuration of the service domain, configuring the control domain or primary domain and saving the sp-configuration.
Hope you will like it. Please share it in social media to reach the maximum number of people. Thank you for visiting UnixArena.
LDOM CLI Cheatsheet – LDOMS & Zones
More Posts from this Category. Hi thanks for the nice artice it really helpful can you please explain how to add the shared LUN to 2 different Ldoms, in cluster enviorment? Your email address will not be published.
Thanks for the same. Leave a Reply Cancel reply Your email address will not be published.